Product Knowledge

A detailed guide to building anchor materials

Views: 0Posted on: 2018-11-30

The building anchors sold by Daring include the chemical anchor series and the mechanical anchor series. Here we will use chemical anchors and undercut anchors as examples to analyze how to select building anchor materials.

Compared with chemical anchors and undercut anchors, the material selection discussed above applies only to their threaded rods, not to the sleeve or the three-piece set of flat washer, spring washer, and nut. As we know, the national standards for both chemical anchors and undercut anchors are divided into multiple grades, including grade 4.8, 5.8, 6.8, and 8.8, among others. Daring mainly ships two grades: 5.8 and 8.8.

Let us also look at the types of steel commonly used. Steels used to make anchors include Q195, Q235, 35#, 45#, and 40Cr, among others. Q195 and Q235 are ordinary carbon structural steels; 35# and 45# are high-quality carbon structural steels with moderate carbon content; 40Cr is also an alloy medium-carbon steel, with a carbon content between that of 35# and 45# steel.

Material Selection for Grade 4.8 Anchors

We generally use Q195 and Q235 steel as materials for grade 4.8 anchors; after processing, they meet the standard without heat treatment. Compared with the other steels, these two are the least expensive, and Q235 steel in particular is extremely widely used, far surpassing other steels.

Material Selection for Grade 5.8 Anchors

Grade 5.8 anchors have a slightly higher load capacity than grade 4.8, so the material used also changes. We use 35# steel to make grade 5.8 anchors; once produced, they directly meet the grade 5.8 standard without any additional quenching and tempering treatment.

Material Selection for Grade 6.8 Anchors

When an anchor grade of 6.8 is required, 45# steel can be selected as the material, which basically meets the standard after processing. Alternatively, 35# steel can be heat-treated to achieve the corresponding strength.

Material Selection for Grade 8.8 Anchors

Grade 8.8 anchors generally use 45# steel as the material and then undergo heat treatment to reach grade 8.8 strength. Some suppliers use 35# steel with heat treatment to reach the grade 8.8 standard, but 35# steel has a relatively high probability of problems during heat treatment; its large dispersion leads to unstable mechanical properties and relatively high brittleness. None of Daring's grade 8.8 anchors use 35# steel as a raw material.

However, 45# steel also has relative instability during heat treatment, especially for small-size anchors: when the material surface reaches grade 8.8 strength, its interior has often already reached grade 10.9 strength. Although anchors produced this way have mechanical properties exceeding grade 8.8, they are rather brittle and are difficult to pass a bending test. 40Cr steel, which is about half again as expensive as 45# steel, does not have this problem: its overall performance is very good, its initial grade is relatively close to grade 8.8, and it is less sensitive to heat treatment. Therefore,40Cr steel is more suitable for the threaded rods of small-size (M12 and below) anchors, while 45# steel can be used as the processing material for large-size (M16 and above) anchors.

Application of Stainless Steel Materials

The stainless steels commonly used for anchors are grades 304 and 316, which have stable chemical properties and good mechanical properties. Anchors made of stainless steel have good overall performance, but they are relatively expensive and are not widely used in practice.



Back to Daring Home  Back to Top