Having learned about the classification of back bolt drilling machines, we know that portable drilling machines can themselves be divided into two types: swing-drill and straight-drill, which are used in different ways. This article only introduces the operating method of Daring's own straight-drill portable back bolt drilling machine.
The portable back bolt drilling machine delivered by Daring weighs only 11 kg as a complete unit, fully living up to the word 'portable'. Of course, there is one issue here: drilling panels requires a water pump and an air pump to work together. Both are standard products, and in order to save customers shipping costs, Daring does not supply them—customers need to purchase them themselves.

Figure 1 Portable back bolt drilling machine
Operating steps
The straight-drill portable back bolt drilling machine is relatively easy to use; its operating steps are as follows, and following them will generally avoid problems.
1 Connect the water inlet pipe of the reaming machine to the water pump, and the air inlet pipe to the air pump;
2 Press the drilling handle down so that the drill bit is close against the panel surface, use the depth adjustment device to set the drilling depth accurately, and tighten the limit adjustment screw;
3 Open the air valve so that the machine attaches to the panel by suction;
4 Turn on and lock the power switch of the reaming machine,press the drilling handle down into position and, without releasing it, press the reaming handle down to perform reaming;
5 Once reaming is in place,release the reaming handle first, then release the drilling handle;
6 Close the air valve and move the machine to the next hole position;
7 Repeat steps 2-6 to drill multiple holes;
8 After drilling is complete, cut off the power to the drilling machine, water pump, and air pump.
Precautions
1 The self-purchased water pump is a750 W self-priming water pump, and the air pump is a3 hp air pump。
2 The power socket should be fitted with a residual current device, the socket should be 1.5-2 m above the ground, and the voltage controlled at about 220 V; too high or too low will damage the motor itself;
3 The water inlet valve must be opened before starting the machine,operating without water will burn out the drill bit and damage the machine。
4 Clean water should be used as cooling water, with water pressure maintained at 3-6 kg/cm².If no water is supplied to the drill bit within ten seconds of starting, the machine should be shut down immediately for inspection.
5 When drilling or reaming, excessive pressure on the handle should be avoided to prevent damage to the motor and drill bit.
6 Before starting the machine or changing the drill bit, check that the locating pin and O-ring (or wire) are properly installed.
7 The drill bit is sintered from a diamond formulation; for the first 10-20 holes, before the diamond grit is widely exposed, drilling should be done at a slow speed.
