The surface-mounted back bolt method is one form of the frameless back bolt method, mostly used for dry-hung panels on low-rise buildings, and is also widely used for dry-hung interior panels.
Compared with the framed back bolt method, the surface-mounted method is much simpler to construct. It allows direct work on the concrete and avoids the trouble of installing framing. Its installation steps are as follows:
(1) Drill back bolt holes on the back of the panel, two holes per panel.
(2) Install the back bolts on the panel and connect them to the steel strips.
(3) Use an impact drill to make holes at the fixing positions on the wall; for an M10 concrete screw anchor, only an M10 hole is needed.
(4) Use concrete screw anchors to fix the steel strips connected to the panel on the wall, then fill the space between the panel and the concrete with cement mortar.

Figure 1. Surface-mounted back bolt method
P.S. Generally, the panels dry-hung with the surface-mounted back bolt method are thin panels, and there are relatively high requirements for the distance between the panel and the concrete; two-piece screw-in back bolts are often used to fix the panels to save internal space. This is the main difference between the surface-mounted back bolt method and the insert-hanging back bolt method. In addition, the installation materials provided by Daring include concrete screw anchors, so you should also learn about the installation method of concrete screw anchors (with diagrams).
