Product Knowledge

Installation sequence for the insert-hung back bolt method (with diagrams)

Views: 0Posted on: 2018-07-25

The insert-hanging back bolt is one form of the frameless back bolt method, mostly used for dry-hung cladding on low-rise buildings, and can also be used for replacing curtain wall panels.

Compared with the framed back bolt method, the insert-hanging method is much simpler to construct. It allows direct work on the concrete and avoids the trouble of installing framing. Its installation steps are as follows:

(1) Drill back bolt holes of the corresponding size in the dry-hung panel; the hole positions must meet the basic principles of back bolt drilling. Generally, when using this method, oversized panels should not be used.

(2) Install the back bolts on the panel, insert rubber gaskets, and then connect the insert-hanging fittings to the panel.

(3) Mark the panel layout on the wall surface and drill holes with an impact drill at the corresponding positions. For an M10 inserting rod (generally the only size used), the drill hole diameter is M14 (to allow adhesive injection, easier installation, and slight positional adjustment).

(4) After drilling, use a brush and a blower to clean the dust from the hole, then inject an appropriate amount of anchoring adhesive.

(5) Push the panel with the installed inserting rod into the hole (the anchoring adhesive should overflow, indicating that the hole is fully filled). Support the underside of the panel with wooden wedges or steel nails, and once the adhesive has cured and taken load, the supports beneath the panel can be removed.

(6) Construction proceeds layer by layer from the bottom upward.

Insert-hanging methodFigure 1. Installation method of the insert-hanging method

Insert-hanging method

Figure 2. One back bolt arrangement of the insert-hanging method

P.S. For the use of anchoring adhesive, refer to the instructions for reverse-cone chemical anchors. The back bolt shown in the diagram is a screw-in back bolt; in practice, a hammer-in back bolt may also be used depending on the panel thickness.



Back to Daring Home  Back to Top