Product Knowledge

How to Use High-Strength Chemical Anchors (with Diagrams)

Views: 0Posted on: 2018-05-25

Chemical anchors are used in large quantities throughout the country, but it is difficult to find a good product. The vast majority of chemical anchors on the market are substandard, non-compliant products made with cut corners; it is precisely these non-standard products flooding the market that have built the high-rise buildings we see everywhere—one hardly knows whether to feel joy or sorrow.

That may seem beside the point; the chemical anchors we are referring to here are those used together with a resin capsule,high-strength chemical anchors. As the most commonly used anchor in building anchoring systems, the installation steps of the high-strength chemical anchor should be thoroughly understood and mastered.

High-strength chemical anchor

Figure 1. High-strength chemical anchor

The installation steps for a high-strength chemical anchor are as follows:

(1) Drill a hole of the corresponding diameter and depth according to the product instructions;

(2) Use a dust blower to blow out the hole at least twice;

(3) Use a brush to clean dust from the hole wall at least twice;

(4) Use the dust blower again to blow out the hole until no dust comes out;

(5) Insert the chemical anchor resin capsule;

(6) Use a torque drill to screw in the chemical anchor to complete the anchoring.

P.S. The chemical anchor resin capsule will not cure at temperatures below -5°C.

Chemical anchor installation steps

Figure 2. Chemical anchor installation steps

As above, steps (2), (3), and (4) are intended to remove dust adhering inside the hole and on the hole wall, so as to prevent degradation or even failure of the chemical compound's mechanical properties and the resulting hazards. The author has encountered many installers who install chemical anchors without blowing out the hole at all; there is little that can be done about this—a good product must be combined with good installation practice. Daring believes every employee should have a sufficient sense of professional ethics, especially management personnel, whose conduct can directly determine the quality of an entire project.



Back to Daring Home  Back to Top