Product Knowledge

How to use a benchtop back bolt drilling machine

Views: 0Posted on: 2018-09-14

Like portable back bolt drilling machines, benchtop back bolt drilling machines are also divided into straight-drill and swing-drill types, which differ considerably in use. This article introduces only the operating method of Daring's own straight-drill benchtop back bolt drilling machine.

A benchtop back bolt drilling machine can weigh 300-400 kg and integrates auxiliary equipment such as a vacuum pump and water pump. It is suitable for panels with uniform dimensions and hole positions, and is generally used in stone factories and other places where large-volume drilling is required. Because the benchtop back bolt drilling machine has twin heads that can work simultaneously, drilling efficiency is relatively high when the supply of panels to be drilled is sufficient.

Fully automatic twin-head back bolt drilling machine

Figure 1 Benchtop fully automatic twin-head drilling machine

Operating steps

A benchtop back bolt drilling machine occupies a relatively large area and has somewhat higher requirements for the construction site; its operating steps are as follows:

1 Switch on the power to the air compressor and control box, then turn on the water supply;

2 Place the panel and use the scale to adjust the hole positions;

3 Adjust the scale to set the drilling depth and tighten the limit adjustment screw;

4 Open the pneumatic hand-pull valve;

5 Turn on the power switch of the reaming machine, press the drilling handle and reaming handle to drill and ream;

6 After drilling is complete, close the pneumatic hand-pull valve and remove the panel;

7 Repeat steps 2-6 to drill multiple holes;

8 After drilling, cut off all power and water supply to the drilling machine.

Precautions

1 First switch on the power to the air compressor and control box, then turn on the water supply;

2 Clean water should be used as cooling water, with water pressure maintained between 0.3 MPa and 0.6 MPa; if no water is supplied to the drill bit within ten seconds of starting, the machine must be stopped immediately for inspection;

3 If water supply to the drill bit suddenly stops during drilling, the machine should be stopped immediately for inspection;

4 Before starting the machine or changing the drill bit, check that the locating pin and O-ring (wire) are properly installed;

5 When drilling or reaming, excessive pressure on the handle should be avoided to prevent damage to the motor and drill bit. The reaming handle may be pressed only after the drilling has reached the required depth. After reaming is complete, retract the reaming handle first, then retract the drilling handle.



Back to Daring Home  Back to Top