Product Knowledge

Calculating adhesive consumption for injection anchoring adhesive

Views: 0Posted on: 2018-08-27

As we know, injection anchoring adhesive is often used together with special reverse-cone chemical anchors and capsule chemical anchors. Injection anchoring adhesive is usually two-component; it is dispensed from a dispensing gun and then mixed evenly through a mixing nozzle before use.

injection anchoring adhesive.jpg

Figure 1 Injection anchoring adhesive

When using injection anchoring adhesive, try to ensure there are no air bubbles in the hole, and it is advisable to have a small amount of adhesive overflow after the anchor is screwed in. Proper calculation of the adhesive quantity can effectively save costs.

Taking an M12×160 reverse-cone chemical anchor as an example, its embedment depth is 110 mm, the anchor diameter is 12 mm, and the drilling diameter is 14 mm. Here we calculate an extreme case:

Total hole volume: π×7²×110=16933 mm³≈17 ml

Anchor volume within the embedment depth: π×6²×110=12441 mm³≈12.5 ml

Then the adhesive volume in the hole is: 17-12.5=4.5 ml

Allowing for a small amount of overflow, 5 ml is enough to install one M12 chemical anchor. However, due to waste during dispensing, drilling, and construction, in our experience the average adhesive consumption for installing one M12 chemical anchor is about 10-12 ml. When calculating,we generally calculate the anchoring adhesive quantity based on the adhesive filling about 2/3 of the total hole volume:

Table 1. Anchoring adhesive consumption for chemical anchors

Chemical anchor model

Hole diameter (mm)

Embedment depth (mm)

Adhesive consumption (ml)

Number of holes per 390 ml cartridge

M12×160

14

110

10-12

28

M16×190

18

125

21-25

15

M20×260

25

170

55-60

6

M24×300

28

210

86-90

4

M30×380

35

280

170-180

2

The table gives estimated adhesive consumption values for commonly used chemical anchor models, including a small amount of overflow and other allowances. Each Daring anchoring adhesive cartridge has a capacity of 390 ml; after deducting the adhesive at the head and tail, the usable amount is about 350-360 ml. The approximate number of holes is for reference only.

When we encounter non-standard chemical anchor specifications, we need to calculate the adhesive quantity ourselves. Here is a simple demonstration based on the rules described above:

Taking an M20×500 chemical anchor as an example, with a provisional embedment depth of 200 mm and a hole diameter of 25 mm, the adhesive consumption is as follows:

2/3×(π×12.5²×200)=98175mm³≈98ml。

Combined with the capacity of each anchoring adhesive cartridge, the required number of cartridges can be easily calculated. It is worth noting thatdispensing adhesive requires experience; once you understand and become familiar with how to use injection anchoring adhesive, you can control the adhesive quantity well and avoid waste.



Back to Daring Home  Back to Top